Filter
Top Products
8. Snap guard into position as shown.
9. Remove knob and washer.., lift guard up.
10. Loosen the two MOTOR BASE CLAMP SCREWS and
rotate the motor so that the ventilation slots are facing
downward, tighten base clamp screws.
11. Install the 2_t/2 "' pulley on motor and move the
motor sideways until the motor pulley is aligned with
the pulley on the machine.
12. Install V-Belt and PUSH down on motor to apply
tension to the belt and tighten nuts on motor
mounting bolts.
NOTE: it is only necessary to apply enough tension
to the belt to prevent it from sJipping in
pulleys while running.
13, After motor and V-belt have been installed and adjusted
for alignment and tension install the metal belt guard to
Leg Set using the holes that are letter coded "B" as
shown on page 8.
14. Insert motor cord plug through rectangular opening in
side stiffener that is directly under switch box and
then into the receptacle. To prevent damage to motor
cord attach it to side stiffeners using the two (2) cord
clips.
MOTOR BASE
CLAMP SCREWS
(BOTH ENDS)
VENTILATION HOLES
FACING DOWNWARD
... , i, ii iI'M_'II' I I'1
JOINTER-PULLEY BELT GUARD
INSTALLATION
I. Attach guard to stand with Hex. Hd. screws and nuts.
Make sure belt does not scrape on guard.
2. Replace washer CONCAVE side up.,. screw on knob,
BOLT.
NUT
WASH ER
(CONCAVE SIDE UP)
!i