Filter
Top Products
rnainfenance
REPLACING CUTTER BLADES
WARNING:FOR YOUR OWN SAFETY. TURN
SWITCH "OFF"AND REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE ADJUSTING, MAINTAIN-
ING, OR LUBRICATING YOUR JOINTER-PLANER.
t. Remove belt guard.
2. Position fence to right . . . approximately 114 in.
beyond cutter blades , , . lock it in pDace.
3. Lower infeed table all the way down.
4. Place block of wood 6-3/4 in. long between cutter-
guard and tence.
BLOCK OF WOOD
!.
j-
5. Hold cutterhead pulley firmly with one hand and
loosen lockscrews in each wedge using a 5/32 in,
setscrew wrench,
BLADE
WEDGE
L! FTE R LOCKSCR EW
SCREW
WEDGE
5/32 IN.
SETSCREW
WRENCH
HOLD PULLEY
FIRMLY
TURN COUNTER
CLOCKWISE
FENCE NOT SHOWN
FOR PICTURE CLARITY
SMALL SCREWDRIVER
6. While holding cutterhead pulley firmly with one hand,
gently pry up each wedge using a screwdriver, . . re-
move wedges and blades.
21