Filter
Top Products
a.
b,
:!:'/i_I_:i__:i?_i;_:_:::' :::i,_::: i: :_:_::i:/ ::ii::!;_:i::::}::i_I:_i_:_:/!: :: : ::
Insert a pencit in space at end of cutterhead to
hold cutterguard open.
Place a straightedge (large square or tong level) on
outfeed table. First along one side than along the
other.
c. Raise infeed table until it touches straightedge.
d,
Sight between table and straightedge to determine
high or low condition of end of infeed table.
ROTATE
BLADE OUT OF
WA /
PENCIL / __
OU FEED "___-__._._
TABLE_
It is easier to adjust the infeed table while the Jointer is
setting on your workbench.
Do not turn the Jointer on its side or upside down to
adjust it.
Attach a strip of wood to two blocks of wood 10 in. high.
Drive enough nails into the strip so that Jointer does
not tip over while resting on blocks.
a. Remove motor cord from outlet in switch box.
b. Remove Jointer pulley guard and V-belt.
c. Remove Jointer from stand.
d. Lower the infeed table,
e, Place Jointer on blocks.
YOUR WORK
BENCH
f. Insert a pencil in space at end of cutterhead to
hold cutterguard open.
g, Wrap a piece of cardboard around cutterhead to
protect your fingers and the blades , . . secure
cardboard with a piece of tape.
CARDBOARD"
15