Filter
Top Products
FULL ONE-YEAR WARRANTY ON CRAFTSMAN RADIAL DRILL PRESS
If within one year from date of purchase, this Craftsman RADIAL DRILL PRESS fails due to a defect in materi-
al or workmanship, Sears will repair it, free of charge
WARRANTY SERVICE IS AVAILABLE BY CONTACTING THE NEAREST SEARS STORE OR SERVICE
CENTER IN THE UNITED STATES,
. This warranty gives you specific legal rights and you may also have other rightsthat vary from state to state
Sears, Roebuck and Co., 13/817WA, Hoffman Estates, IL 60179.
GENERAL SAFETY RULES FOR POWER TOOLS
KNOW YOUR POWER TOOL
For your own safety, read the owner's manual carefully
Learn the application and limitations as well as the specific
hazards peculiar to this tool
2 GROUNDING INSTRUCTIONS
A. All grounded, cord-connected tools:
In the event of a malfunction or breakdown, grounding pro-
vides a path of least resistance for electric current to
reduce the risk of electric shock This tool is equipped with
an electric cord having an equipment-grounding conductor
and a grounding plug The plug must be plugged into a
matching outlet that is properly installed and grounded in
accordance with all local codes and ordinances
Do not modify the plug provided - if it will not fit the outlet,
have the proper outlet installed by a qualified electrician
Improper connection of the equipment-grounding conduc*
tot can result in a risk of electric shock The conductor with
insulation having an outer surface that is green with or
without yellow stripes is the equipment-grounding conduc-
tor If repair or replacement of the electric cord or plug is
necessary, do not connect the equipment-grounding con-
ductor to a live terminal
Check with a qualified electrician of serviceman if the
grounding instructions are not completely understood, or if
in doubt as to whether the tool is properly grounded
The use of any Extension Cord will cause some loss of
power To keep this to a minimum and to prevent over-
heating and motor buro-out, use the table below to deter÷
mine the MINIMUM wire size (A W.G ) Extension Cord
Use only 3-wire extension cords :_hathave 3-prong ground-
ing plugs, and 3-pole receptacles that accept the tool's
plug
Extension Cord Length Wire Size, AW G
25 Feet 16
50 Feet 16
100 Feet 14
Extension Cords suitable for use with your Radial Drill
Press are available at your nearest Sears Catalog Order or
Retail Store
Repair or replace damaged or worn cord immediately
S Grounded, cord-connected tools intended for use on a
supply circuit having a nominal rating less than 150 volts:
Grounding Pin
MetalS_
rofGroundedII ['1)II
utlet Box
{A) (a)
Adapter
Groundin(
Figure I - Wiring Methods
This tool is intended for use on a circuit that has an outlet
that looks like the one illustrated in Sketch A in Figure 1,
The tool has a grounding plug that looks like the plug illus-
trated in Sketch A in Figure 1 A temporary adapter, which
looks like the adapter illustrated in Sketches B and C, may
be used to connect this plug to a 2-pole receptacle as
shown in Sketch B if a properly grounded outlet is not
available The temporary adapter should be used only until
a properly grounded outlet can be installed by a qualified
electrician The green-colored rigid ea_:,lug, etc extending
from the adapter must be connected to a permanent
ground such as a properly grounded outlet box
3 KEEP GUARDS IN PLACE
in working order and in proper adjustment and alignment,
2