Filter
Top Products
I
7 Make sure bottom of Spindle Shaft (REF 42) and bore of
Chuck (REF 46) are clean and free of grease Press
Chuck up onto Spindle Shaft_
NOTE: To avoid damage to Chuck, rotate Chuck barrel
until jaws are fully open.
8 Using a mallet or a block of wood and hammer, firmly tap
Chuck upward into position onto Spindle Shaft
f
nNSTALUNG RADUAL DRULL PRESS
WARNING: BEFORE USING RADIAL DRILL PRESS_
MAKE SURE IT IS ATTACHED TO A FIRM AND STABLE SUP-
PORT SURFACE USING CARRIAGE BOLTS AND WING
NUTS PROVIDED.
1 Choose an area that allows sufficient clearance to take
full advantage of the Radial Drill Press's lateral, rota-
tional, and tilt motions
2 Bolt Radial Drill Press to a firm and stable surface using
Carriage Bolts and Wing Nuts provided, Be sure bolts
pass entirely through mounting surface and are at least
5/16-18 standard strength_ Tighten all bolts and wing nuts
securely
3/8" Diameter
2 Hotes
12 3/4" Fore and Aft Travel
Head Tilts 45"
C_ockwise and 90"
Counter-clockwise
360" Rotation
6 1/4"
Use Carriage Bolts and
Wing Nuts Provided
7