Filter
Top Products
ASSEMBLY
WARNING: FOR YOUR OWN SAFETY, NEVER CONNECT
THE RADIAL DRILL PRESS TO A POWER SOURCE UNTIL
ALL ASSEMBLY STEPS ARE COMPLETE_ AND YOU HAVE
READ AND UNDERSTOOD SAFETY AND OPERATIONAL
INSTRUCTIONS=
CAUTION: Do NOT ALLOW BRAKE FLUIDS_ GASOLINE,
PENETRATING OILS 1 ETC,_ TO COME IN CONTACT WITH
PLASTIC PARTS, THESE SOLUTIONS CONTAIN CHEMICALS
THAT CAN DAMAGE AND/OR DESTROY PLASTICS,
1 Assemble Column and Flange Assembly (REF 4) to Base
Assembly (REF 1) using four 8mm x 25mm bolts (REF 5).
Bracket making sure that the teeth are engaged in the
Table Lift Gear inside bracket Slide rack and bracket
assembly onto column until angled end at bottom of rack
fits into top of column flange
Place LiftHandle (REF 10) on Worm Pinion Shaft extending
from Table Bracket Align flat on pinion shaft with set
screw (REF 11) and tighten
NOTE: Before installing drill head assembly, find a per-
manent location for radial drill press and fasten base
down using Carriage Bolts (REF 96) and Wing Nuts (REF
97) provided. BE SURE BOLTS PASS ENTIRELY
THROUGH MOUNTING SURFACE. (See Installing Radial
Drill Press section on page 7,)
4 Race Lock Shoe (REF 88) from loose parts bag into cast
pocket in Column Head Assembly (REF 83) then slide
Column Head Assembly with Drilt Head Assembly down
onto Column as shown Be very careful to hold Lock Shoe
in place during assembly to prevent it from falling down
inside column Be sure to engage Vertical Rack with angle
on bottom of Column Head Drill head should rotate freely
around column
2 Slide Worm Pinion (REF 9) into Table Bracket (REF 6) until
shaft extends from hole and teeth engage with Table Lift
Gear (REF 7) Lower Vertical Rack (REF 15) into Table
Handle
Bar
Lock
Lock
Handle
Lift
Lift
Handle
5 Attach one Lock Handle (REF 14) to Table Bracket and
two Lock Handles to Column Head_
6, Attach three Handle Bars (REF 37) into threaded holes
on head of Feed Shaft Assembly (REF 34)
Table Bracket