Filter
Top Products
SAFETY RULES FOR DRILL PRESSES
1 DO NOT USE until unit is completely assembled and installed
according to instructions
2 USE ONLY CHUCK KEY PROVIDED WiTH YOUR RADIAL
DRILL PRESS It is equipped with a self-ejecting pin that elimi-
nates hazard of leaving key in chuck
3 ALWAYS WEAR EYE PROTECTION
4 DO NOT WEAR Gloves, necktie or loose fitting ciothing
5 BE SURE DRILL BIT or cutting tool is securely locked in chuck
6 USE RECOMMENDED SPEED for drill accessory and workpiece
material
7 ADJUST TABLE OR DEPTH STOP to prevent drilling into table
work surface
8 NEVER USE YOUR HANDS TO HOLD workpiece during drilling
Clamp it to work surface or use a vise to secure workpiece and
prevent rotation
9 NEVER OPERATE drill press if any part is damaged or broken
until it is properly repaired or replaced
10 NEVER pLACE YOUR FINGERS in a position where drill or cut-
ting tool could contact them if part should shift unexpectedly
11 NEVER PERFORM LAYOUT, assembly or setup work on drill
press with cutting tool rotating
12 SHUT OFF POWER, remove drill or cutting too!, and clean table
before leaving machine
TABLE OF CONTENTS
WARRANTY ................................................................. 2
GENERAL SAFETY RULES FOR POWER TOOLS .............. 2, 3
SAFETY RULES FOR DRILL PRESSES ................................... 4
TOOLS REQUIRED .................................................................. 5
UNPACKING AND CHECKING CONTENTS ........................... 5
TABLE OF LOOSE PARTS ........................................................... 5
ASSEMBLY ............................................................................................6, 7
INSTALLING RADIAL DRILL PRESS ........................................ 7
CONTROLS AND ADJUSTMENTS ............................................ 8-11
On/Off Switch .................................................................... 8
Table Adjustment ......................................................... 8
Depth Stop Adjustment ............................................. 8
Spindle Return Spring Adjustment ...................................... 8, 9
Spindle Speeds ............................................................... 9
Changing Speeds ....................... ' ............................ 9
Belt Tension Adjustment ............................................. 9, 10
Tilting Drill Head .................................................... 10
Rotating Drill Head .......................................... 10
Moving Drill Head In or Out ..................................... 10
Adjusting Spindle Perpendicular to Table ....................... 11
Alignment of Motor Pulley to Spindle Pulley .................. 11
OPERATION ..................................................................12
Correct Drilling Speeds ................................................ 12
Drilling Wood ........................................................... 12
Drilling Metal ............................................................... 12
MAINTENANCE ........................................................ 12
ACCESSORIES ...................................................... 13
REPAIR PARTS ........................................................... 14, 15
TROUBLESHOOTING ................................................. 16
HOW TO ORDER REPLACEMENT PARTS ...................... 16