Sears 28.71988 Battery Charger User Manual


  Open as PDF
of 12
 
• 4 •
ASSEMBLY INSTRUCTIONS5.
Remove all cord wraps and uncoil the cables prior to using the jump starter.
FEATURES6.
Jump Start On/Off switch 1.
Inverter/Compressor switch2.
Digital Display3.
Plastic lens cover4.
(2) Light bulbs5.
(2) 12V DC power outlets6.
(2) 110V AC household 7.
power outlets.
USB port8.
Power Switch (9. Light/Display)
Air compressor gauge10.
Air compressor hose11.
Air compressor accessory bag12.
Air compressor ball ination 13.
adapter
(2) Air compressor 14.
miscellaneous ination adapters
ON/O15. FF inator/deator switch
High-ow inator port16.
Inator/deator hose end adapter17.
High-ow deator port18.
Inator/deator hose19.
(2) Cables with clamps20.
(3) Inator/deator hose 21.
device adapters
Wall Charger (not shown)22.
Charger Port23.
Replaceable Battery (not shown)24.
1
2
3
4
5
6
7
8
9
21
10
18
16
17
15
19
13
14
12
11
20
23
CHARGING THE INTERNAL BATTERY OF THE JUMP STARTER7.
IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS TO KEEP THE JUMP STARTER’S INTERNAL BATTERY
FULLY CHARGED.
To check the internal battery’s charge status, toggle the Light/Display switch to the 7.1
DISPLAY position. The Digital Display will show the battery’s percent of charge. Charge
the internal battery if the display shows it is under 100%.
NOTE: The internal battery’s percent of charge is most accurate when the jump starter
has been disconnected from all devices and charging sources for a few hours.
Charging the Internal Battery using the Included Wall Charger.7.2
To charge, plug the included wall charger into the charger port on the back of the 1.
jump starter.
Plug the wall charger into a 120V AC electrical wall outlet.2.
While the jump starter is charging, the battery’s percent of charge will be displayed. 3.
When the internal battery is fully charged, the display will show 100. Complete
charging may take up to 72 hours. The jump starter is then ready to use.
 previous next