Filter
Top Products
• 7 •
NOTE: To prevent overheating, the compressor has built-in thermal protection that
will turn the compressor off before it overheats. If the compressor shuts off, wait a few
minutes and it will automatically restart when the compressor cools.
NOTE: The air compressor is rated for 150 PSI.
Estimated Time for Inating
Vehicle Tires 13" to 16" 6 to 24 minutes
Bike Tire 1 to 3 minutes
Sports Balls 30 seconds
These times are approximate; use the air compressor gauge to ensure the proper
pressure has been reached. Do not overinate.
Using the Inator8.7
Risk of explosion.
Read instructions of the product being inated before using the inator. Avoid
overination, do not exceed the manufacturer’s recommended pressures. Do
not leave the inator unattended during use.
Ensure that the battery clips are securely on the storage holders.1.
Attach the corrugated hose with end adapter to the high-ow inator port 2.
located near the inator ON/OFF switch on the back of the jump starter.
The main accessory adapter attached to the corrugated hose accommodates up to 4 3.
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
Insert the adapter into the product to be inated.4.
Push the Inator switch to the ON position and inate the product.5.
When product is inated to the desired level, push the Inator switch to the OFF 6.
position and remove the adapter.
Estimated Time for Inating
24" Beach Ball 1 to 3 minutes
Pool Raft 4 to 6 minutes
Queen-size Air Mattress 4 to 8 minutes
2 Person Boat 8 to 10 minutes
Times are estimates and will vary depending on size and product features.
Using the Deator8.8
Ensure that the battery clips are securely on the storage holders.1.
Attach the corrugated hose with the end adapter to the high-ow deator port, which 2.
is located on the side of the jump starter.
The main accessory adapter attached to the corrugated hose accommodates up to 4 3.
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
Insert the adapter into the item to be deated.4.
Push the Inator switch to the ON position and deate the item.5.
When the product is deated to the desired level, push the Inator switch to the OFF 6.
position and remove the adapter.
Before Using the Inverter8.9
Important Safety Instructions:
Keep the jump starter well ventilated in order to properly disperse heat generated 1.
while it is in use. Make sure there are several inches of clearance around the top and
sides, and do not block the vents on the back of the jump starter.
Make sure the jump starter is not close to any potential source of ammable fumes, 2.
gases or clothing.