Filter
Top Products
ALIGNING BLADE TO TABLE AT 0° BEVEL
See Figures 30A - 30D,
This procedure squares the blade to the table at 0°
bevel (vertical) so the blade angle will be accurate. If
the blade is not at 0° bevel, follow the steps below to
rotate slightly, You will need a framing square and a
1/4 in, hex key,
• Position the blade in front of the fence. Lower the
blade with the elevating handwheel until it just
clears the front table.
• Lock the following controls:
bevel lock lever below the handle,
carriage lock knob on the left side,
arm lock knob on top of the arm, and
yoke lock handle below the yoke, on the right.
• Stand a framing square on the table with the short
leg pointing up against the saw blade and the long
leg parallel to the fence, Place the square flat
against the blade between two teeth.
• If both the top and bottom of the saw blade are flat
against the square, no adjustment is needed,
• If the saw blade gaps at the top or bottom, remove
the bevel index cap by removing the two phillips
head screws (below the handle), You will see four
socket head screws,
• Loosen the socket head screws with a 1/4 in. hex
key, Rotate the motor slightly while holding the
square against the saw blade and table top,
• Slightly tighten each of the four screws and recheck
the blade and framing square,
ARMLOCKKNOB
• If there are no gaps, fully tighten each screw, If
there is still a gap, repeat the previous two steps.
• Check the bevel indicator on the yoke assembly
near the handle, It should read 0°. If it does not,
reset it by loosening the screws and rotating the
bevel index cap, Retighten the two screws,
• Loosen the carriage lock knob,
BLADESQUARETO TABLE
NOADJUSTMENTNEEDED
FRAMING
SQUARE
\
I
_ BLADE
TABLEj Fig, 30B
FRAMING
SQUARE
GAPj
J
GAP
BLADE
t BLADE
FRONTTABLE
BEVEL
INDEXCAP
BEVEL
LOCK
LEVER
GAP-ADJUSTMENTNEEDED Fig. 30C
BEVELINDEX
CAP REMOVED
ELEVATING SOCKET BEVEL
HANDWHEEL Fig. 30A HEADSCREWS LOCK LEVER
Fig. 30D
rRnR'$MI:1N_RADIALSAW 315.2201O0 38