Filter
Top Products
REMOVABLE OVEN DOOR
To remove:
1. Open the door to the stop position (see illustration).
2. Grasp the door at each side and lift up and off the
hinges.
NOTE: DO NOT lift the oven door by the handle.
Glass breakage or damage to the door
could result.
NOTE: When the door is removed and
hinge arms are at stop position, do
not bump or try to move the hinge
arms. The hinges could snap back
causing an injury to the hands or
damage to the porcelain on the front
of the range. Cover the hinges with
toweling or empty towel rolls while
working in the oven area.
To replace:
1. Hold the door over the hinges with the slots at the
bottom edge of the door lined up with the hinges.
The hinge arms must still be in the stop
position.
STOP (BROIL)
POSITION
2. Slide the door down onto the hinges as far as it will
go and close the door.
REMOVABLE STORAGE DRAWER
This drawer gives you space for keeping
cookware and bakeware. Plastics and
flammable material should not be kept in
this drawer.
Do not overload the storage drawer. If the drawer is too
heavy, it may slip off the track when opened. To open
the drawer, grasp the center of the handle and pull
straight out,
To remove: pull drawer straight out and lift over the
guide stops.
GUIDE STOP
REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when
installing or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pair of rack
guides.
2. Push the rack in until you reach the bump in the rack
guide, then lift the front of the rack a bit and push the
rack all the way in.
To remove:
1. Pull the oven rack out, then up.
The shelves are designed with stop locks so when
placed correctly on the shelf support, and extended
from the oven, the stop lock prevents the racks from
tilting when you are removing food from the racks or
placing toed on them.
Note: If oven racks are left in the range during a
clean cycle, they will darken, lose their luster
and become hard to slide. If you choose to leave
the racks in the oven, you can polish the edges
of the racks with steel wool and apply a small
amount of vegetable oil to the rack edges after
the self-clean cycle. This will make the racks
easier to slide.
To replace: lift over the guide stops and slide drawer
into place.
20 NGMNT48-1