Filter
Top Products
4 - 12
Holding jig
Water
Ferrule tip
Soft brush
NOTE
When removing the holding jig
from the polishing unit, lift the
holding jig up so the ferrules do
not touch the polishing film.
Step 9 Clean the holding jig and the
tips of the ferrules under
running water using the brush.
After cleaning, clean the brush,
removing all polishing grit or
other matter.
NOTE
There is no problem if washing is
done in the washing container,
but using running water is
preferred.
Step 10 Take the ferrules out of the
holding jig, undo the wire ties,
wash the ferrule tips with water
and dry the tips of the ferrules
with cleaning paper.
Step 11 Clean the ferrules with
cleaning paper and ethyl
alcohol. Clean the surface of
the polishing film with cleaning
paper and water.
NOTE
Do not leave any polishing fluid
on the polishing film because the
polishing fluid can dry on the
polishing film, scratching the
ferrules if the film is used again.
If polishing will not be done for a
period of time, keep the polishing
film immersed in water so that
any polishing fluid on it will not
dry.