Filter
Top Products
5 - 1
CHAPTER 5
MAINTENANCE
In order that the machine functions correctly, the following maintenance operations
must be carried out after completion of polishing operations.
5.1 CLEANING AFTER POLISHING
After finishing polishing, or when stopping polishing for a period of time, clean
the OFL-12 as well as all of the polishing films carefully with water. If no
cleaning is done, the remaining polishing fluid will harden. Also make sure
that no waterdrops remain on the operation panel.
When the OFL-12 won’t be used for a long time, ultrasonically clean the
holding jig in ethyl alcohol, then oil the holding jig and keep it in a vinyl
envelope.
5.2 CHANGING THE POLISHING FILM
The standard lifetime of a sheet of polishing film is 10 uses (120 ferrules
maximum) (for the abrasive paper for adhesive removal the lifetime is only
one use).