Filter
Top Products
DE
EN
FR
IT
ES
NL
Putting the charger into operation
10
Connecting the charger to a PC
You can connect one or several chargers to a PC. The supplied “Conference
Control” software allows you to centrally and easily configure and monitor
several chargers and receivers.
For this, the charger requires a network connection with a PC. The charger
can be connected directly to an individual PC or integrated into an existing
network. The charger cannot communicate with several PCs at the same
time.
The charger also functions without connection to a PC.
Connecting the network cable
̈ Use a standard network cable (RJ45 CAT.5E, not included in the delivery)
to connect the network socket ¾ and an Ethernet socket of the
network.
̈ Install the “Conference Control” software.
̈ Configure the network communication between the “Conference
Control” software and the charger (the instruction manual of the
“Conference Control” software on the enclosed CD).
Connecting the charger to and disconnecting it from the
mains
To connect the charger to the mains:
̈ Connect the mains cable (not included in the delivery) to the mains
socket µ.
̈ Plug the mains connector into a wall socket.
To disconnect the charger from the mains:
̈ Pull out the mains connector from the wall socket.
CAUTION! Danger due to electric current!
If you connect the charger to an unsuitable power supply, this
can cause damage to the device!
̈ Use a mains cable with a 3-pin IEC mains connector to
ensure a reliable mains ground connection of the charger –
especially when you are using an extension cable or a
multi-outlet power strip.
̈ Avoid circuit overloading. If necessary, provide overcurrent
protection.