Filter
Top Products
DE
EN
FR
IT
ES
NL
7
Putting the charger into operation
Putting the charger into operation
The charger can be:
• placed on a table or cabinet
• installed in a 19” rack
• installed in a cabinet or similar
When using the “Conference Control” software, it automatically sorts its
charger displays according to ascending serial numbers. The assignment of
the charger displays of the software to the chargers becomes easier and
clearer if you install the chargers according to ascending serial numbers.
Placing the charger on a table or cabinet
The charger has four plastic feet to ensure that it cannot slip on the surface
on which it is placed.
̈ Place the charger on a table, cabinet or similar.
NOTICE! Danger due to heat accumulation!
The charger and the receiver rechargeable batteries can get
very hot during charging. If the heat cannot dissipate, the
devices can be damaged.
̈ Make sure that the air vents of the charger are not covered
or blocked.
̈ Make sure that the ambient temperature of the charger
does not exceed 40°C. If necessary, provide additional
ventilation.
̈ Keep the charger away from heat sources and never expose
it to direct sunlight.
NOTICE! Risk of staining of furniture surfaces!
Some furniture surfaces have been treated with varnish,
polish or synthetics which might cause stains when they
come into contact with other synthetics. Despite a thorough
testing of the synthetics used by us, we cannot rule out the
possibility of staining.
̈ Do not place the charger on delicate surfaces.