Filter
Top Products
-8-
M1102/M1103 16-Speed Drill Press
SAFETY
1. EYE/FACE/HAND PROTECTION. A face shield used with safety glasses is recommended. Always
keep hands and fingers away from the drill bit. Never hold a workpiece by hand while drilling! DO
NOT wear gloves when operating the drill
.
2. GUARD. Only use this machine when the chuck guard is inplace and positioned over the chuck.
3. SECURING BIT. Properly tighten and securely lock the drill bit in the chuck.
4. CORRECT BIT.
Use only round, hex, or triangular shank drill bits.
5. ADJUSTING KEYS AND WRENCHES. Remove all adjusting keys and wrenches before turning the
machine ON.
6. DRILLING SHEET METAL. Never drill sheet metal unless it is securely clamped to the table.
7. SURFACE /WORKPIECE PREPARATION. Never turn the drill press ON before clearing the table
of all objects (tools, scrap wood, etc.) DO NOT drill material that does not have a flat surface,
unless a suitable support is used
.
8. DAMAGED TOOLS. Never use tools in poor condition. Dull or damaged cutting tools are hard to
control and may cause serious injury
.
9. DRILL OPERATION. Never start the drill press with the drill bit pressed against the workpiece.
Feed the drill bit evenly into the workpiece. Back the bit out of deep holes to clear chips.
10. OPERATING SPEED.
Always operate your drill press at speeds that are appropriate for the drill
bit size and the material that you are drilling.
11. MAINTENANCE/SPEED CHANGES. Never do maintenance or change speeds with the machine
plugged in to the power supply.
12. MOUNTING WORKPIECES. Use clamps or vises to secure workpiece before drilling. Position work
so you avoid drilling into the table.
13. TABLE LOCK. Make sure the table lock is tightened before starting the drill press.
14. EXPERIENCING DIFFICULTIES.
If at any time you are experiencing difficulties performing the
intended operation, stop using the machine! Contact our Technical Support at (360) 734-3482.
Safety for Drill Presses
USE this and other machinery with caution
and respect. Always consider safety first,
as it applies to your individual working
conditions. No list of safety guidelines can
be complete—every shop environment is
different. Failure to follow guidelines could
result in serious personal injury, damage
to equipment or poor work results.
READ and understand this
entire instruction manual
before using this machine.
Serious personal injury may
occur if safety and oper
-
ational information is not
understood and followed.
DO NOT risk your safety by
not reading!