Filter
Top Products
-12-
M1102/M1103 16-Speed Drill Press
SET UP
Table Support
The table support must be installed as described to prop-
erly assemble your drill press.
To install the table support:
1. Check to make sure the pinion is inserted into the
table support, as shown in Figure
4, so the pinion
and gear teeth mesh together.
2. Mark the top of the rack, as shown in Figure
5, to
keep track of which end is up.
3. Remove the column ring by loosening the Phillips
head screw, and remove the rack.
Figure 4. Pinion correctly installed in
table support.
Figure 3. Column secured to base.
The column must be secured on the base to properly
assemble your drill press.
To secure the column to the base, do these steps:
1. Place the column on the base and align the mounting
holes.
2. Secure the column to the base with the four lock
washers and hex bolts as shown in Figure
3.
Column and Base
Figure 5. Marking top of rack to show
which end is up.
Continued on next page