Filter
Top Products
-17-
M1102/M1103 16-Speed Drill Press
SET UP
Figure 15. Downfeed handles and belt
cover knob installed.
The downfeed handles must be installed to properly oper-
ate the drill press.
To install the downfeed handles, do these steps:
1. Thread the knobs onto the handles, then thread the
handles into the spindle hub, as shown in Figure 15
,
and tighten.
2. Install the belt cover knob in its place (see Figure 15
for location).
Downfeed Handles & Belt
Cover Knob
Spindle Hub
The table must be installed to properly support the
workpiece during operation.
To install the table, do these steps:
1. Insert the table shaft into the table support assem-
bly.
2. Tighten the small locking lever (Figure 16) to secure
the table in the table support assembly.
Table
Figure 16. Table installed.
Belt Cover
Knob