Filter
Top Products
-11-
M1109 Combo Lathe/Mill
SETUP
• Floor Load: Your lathe/mill is a heavy load (1200
lbs.) distributed in a
61
3
/4" x 27
1
/2" footprint. Place
this machine on concrete floors only. The floor
MUST be level, or the lathe/mill frame and ways
may distort over time.
• Working Clearances: Consider existing and
anticipated needs, service panel access, length of
rods to be loaded into the lathe/mill, and space for
auxiliary stands, work tables or other machinery
when establishing a location for your lathe/mill
(see Figure
9 for minimum wall clearances).
• Lighting: Lighting should be bright enough to
eliminate shadow and prevent eye strain.
• Electrical: Outlets must be located near each
machine, so power cords are clear of high-traffic
areas. Follow local electrical codes for proper
installation.
Cleaning Machine
The ways and other unpainted parts of your lathe/mill
are coated with a waxy grease that protects them from
corrosion during shipment. Clean this grease off with a
solvent cleaner or citrus-based degreaser. DO NOT use
chlorine-based solvents such as brake parts cleaner, lac
-
quer thinner, or acetone—if you happen to splash some
onto a painted surface, you will ruin the finish.
Machine Placement
ALWAYS work in well-
ventilated areas far from
possible ignition sources
when using solvents to clean
machinery. Many solvents
are toxic when inhaled or
ingested. Use care when
disposing of waste rags
and towels to be sure
they DO NOT create fire
or environmental hazards.
NEVER use gasoline or
petroleum-based solvents
to clean your lathe/mill.
Figure 9. Minimum wall clearances.
MAKE your shop “child safe.”
Ensure that your workplace
is inaccessible to youngsters
by closing and locking all
entrances when you are
away. NEVER allow untrained
visitors in your shop when
assembling, adjusting or
operating equipment.