Filter
Top Products
-15-
Back Stop
The back stop serves as a resting point for the
workpiece while flat sanding on the belt. Install
the back stop to the sanding belt frame using a
5
⁄16"-18 x 1" hex bolt and a
5
⁄16" flat washer as
shown in Figure 12. The back stop can be
removed when sanding long workpieces.
Dust Ports
The dust ports are designed to reduce the
amount of dust on the sander and in the air.
Fasten the belt dust port to the sanding belt
frame using (2) Phillips
®
head screws as shown
in Figure 13. Fasten the disc dust port using (4)
Phillips
®
head screws and nuts as shown in
Figure 14.
Figure 12. Installing back stop.
Figure 13. Installing dust port.
Figure 14. Disc sanding dust port.
Always wear a dust mask
when operating the
W1676. Using this
machine produces saw-
dust which may cause
allergic reactions or res-
piratory problems.