Filter
Top Products
-20-
Vertical Positioning
The belt sander arm can be moved to a vertical
arrangement.
1. Remove the belt dust port.
2. Loosen the two nuts located on the bracket
behind the pulley cover as shown in Figure
23. We recommend using a 12mm open-end
wrench for clearance purposes.
3. When the nuts are loose, rotate the sanding
belt frame to the vertical position as shown
in Figure 24.
4. Tighten down the nuts that were loosened in
Step 2.
The working table can also be repositioned next
to the vertical surface of the sanding belt.
Remove the working table assembly and support
bar from the sander base, and reposition it in
the mounting hole behind the motor as shown in
Figure 25.
Figure 23. Vertical positioning bolts.
Figure 24. Belt sander in vertical position.
Figure 25. Working table mounting hole when
vertical sanding.