Woodstock W1670 Cordless Drill User Manual


  Open as PDF
of 44
 
Whileyoumayneverhavetoadjustthequill-
shaft screw, you should understand its func-
tionandknowhowtoadjustitshouldyouever
need to remove the quill for cleaning. This
screw prevents the quill from rotating during
drillingandsandingprocedures,andifadjusted
incorrectly, the quill may have lash or bind.

 
 Clean and lubricate the quill shaft with a
thin coat of light oil, so the quill travels
freely(see ).
 Loosenthe jamnut(see).
 Move the quill up and down through the
entire range of travel, and turn the quill-
shaft screw inward as far as it can go with-
out binding the quill.
 Tightenthejamnut,andcheckthequill
movement for binding or play while moving
the quill up and down through its entire
range of travel.
 Re-adjustthequill-shaft screw as required.
Clean and oil quill shaft.
Quill-shaftscrewandjamnut.
Quill-Shaft
Screw
Jam
Nut
 Engage the next available spring-cover
lock slot with the locking lug and hold the
spring lock cover tightly against the side of
theheadstock(see ).
 Snug the cover nut against the spring cover
justuntilthenutstops,andthenback-
off the nut approximately
1
⁄3turn,orjust
enough so there is no binding anywhere
along spindle travel path.
 Holdthecovernutandtightenthejamnut
against the cover nut.
-16-
Hold the spring cover tightly.
Cover Nut

LockLug

 previous next