Filter
Top Products
-22-
W1701 1HP Shaper
SERVICE
SERVICE
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
tech-support@shopfox.biz
.
General
MAKE SURE that your machine is
unplugged during all service proce
-
dures! If this warning is ignored, seri
-
ous personal injury may occur.
Your shaper uses a flat-type belt on two drum-style pul-
leys, to compensate for different belt positions as the
spindle height is adjusted.
To adjust belt, do these steps:
1. DISCONNECT SHAPER FROM POWER SOURCE!
2. Loosen the belt adjustment bolts as shown in Figure
37.
3. Slide the motor position to increase or decrease belt
tension, so the belt is snug with about 1/4" deflec
-
tion when pressed lightly with your fingertips.
4. Tighten the belt adjustment bolts.
Belt Adjustment
Figure 37. Adjusting belt tension.