Filter
Top Products
-25-
W1701 1HP Shaper
SERVICE
The fence can be resurfaced or made flat with a jointer
to correct any warping. This procedure should only be
done if the fences will not align with each other after
careful adjustment or they are warped.
To resurface the fence, do these steps:
1. Make sure the fence face mounting screws are far
enough below the surface of the fence that they will
not contact the jointer knives during operation.
Note: New fence faces can easily be made out of
hard wood and resurfaced by using this same proce
-
dure.
2. Align both fence faces as straight as possible, using
a straightedge or your jointer table as an alignment
guide.
3. Resurface the fences on the jointer, as shown in
Figure 42.
Resurfacing Fence
Figure 42. Resurfacing a shaper fence on a
jointer.