Filter
Top Products
-10-
W1713 Owner's Manual (Mfg. Since 6/03)
SETUP
Assembly
The blade guard is designed to
keep your hands and fingers safe.
This guard MUST be properly
installed BEFORE connecting the
scroll saw to power to reduce the
risk of hand or finger injury.
Tools Needed Qty
Phillips Screwdriver #2 .........................................1
Wrench 8mm .....................................................1
To install the blade guard, do these steps:
1. Make sure the saw is disconnected from power.
2. Use the pre-installed Phillips head mounting screw,
hex nut, and washers to install the blade guard onto
the top of the hold-down shoe rod, as shown in
Figure 4.
Note: Over-tightening the mounting screw could
crack the plastic arms of the blade guard.
3. Pivot the guard up-and-down to ensure that it moves
smoothly. If necessary, loosen the mounting screw
until the movement is smooth.
Keep machine disconnected from
power until instructed otherwise.
Figure 4. Blade guard properly installed.
Mounting Screw
Blade
Guard