Filter
Top Products
Model W1784 (Mfg. Since 2/07)
-8-
NOTICE
If you are using pre-finished
flooring material, test the stapler
on a sample strip. If the stapler base
plate is damaging or marring the
flooring surface, replace it with a
new one.
Place the stapler on the flooring
strip, as shown in .
Make sure the cleat on the stapler
base plate is lined up with the edge
of the groove on the flooring strip.
Using the rubber end of the included
hammer, hit the whack cap of the
stapler ONCE with a light to medium
force to shoot a staple into the wood.
Check the staple for satisfactory
penetration.
— If the staple depth is satisfactory,
proceed with your project.
— If the staple depth is too shallow,
slightly increase the air pressure.
— If the staple depth is too deep,
slightly decrease the air pressure.
Staple penetration is not
always consistent due to variations in
the flooring material. If necessary,
use a hammer to finish seating the
staple.
A jammed staple must be cleared before
using the stapler again.
DISCONNECT STAPLER FROM THE AIR
SUPPLY!
Pull the magazine loader handle all
the way back and remove the staple
stick.
Positioning and operating
stapler on flooring strip.