Filter
Top Products
Model W1784 (Mfg. Since 2/07)
-7-
When replacing staples in your Model
W1784, follow these guidelines:
Staple Gauge ............................. 15.5
Staple Length .............................1"–2"
Capacity: .....................................60
DISCONNECT STAPLER FROM THE AIR
SUPPLY!
Slide the magazine loading handle
back until it locks.
Load a staple stick into the magazine
T-slot, as shown in .
Before you operate your stapler, place
five to six drops of the included oil into
the quick connect fitting where the
stapler connects to the air supply.
The Model W1784 comes with two base
plates:
— The thinner base plate is for use
with
3
⁄4" flooring.
— The thicker base plate is for use
with
1
⁄2" flooring.
Install the correct base plate for your
size of flooring material.
Place the flooring stapler on the
floor with the staple discharge facing
down, then connect the air supply.
Position a flooring strip and tap it
into place with the metal side of the
included hammer.
Loading staples into stapler.
Pull the magazine loading handle
back to unlock it, and slide it forward
until the pusher engages the staple
stick.
Always control the magazine
loading handle when sliding the
pusher forward. Allowing the pusher
to fly forward against the stapler
stick will significantly increase wear
of the stapler.