Filter
Top Products
Model W1784 (Mfg. Since 2/07)
-3-
Do not place
your hands near the staple point
of entry. A staple can deflect and
tear through the surface of the
workpiece, puncturing your hand or
fingers.
Never
connect the stapler to pressurized
oxygen or other combustible
gases as a power source. Only use
filtered, lubricated, and regulated
compressed air.
Never point the
stapler at others! Do not keep
the trigger pulled when loading
fasteners, carrying, or holding
tool. Carry the stapler only by the
handle, never by any other part.
Do not carry the stapler by the air
hose. Disconnect the stapler from
the air hose when going up and
down ladders.
Never use gasoline or
other flammable liquids to clean
the stapler; vapors in the stapler
will ignite by a spark and cause it
to explode.
Make sure your air
hose is designed for the tool in
use, is in good condition, and is
long enough to reach your work
without stretching. However, an
overly long air hose in the work
area may be a tripping hazard.
If you
are not sure about the intended
operation, stop using the stapler.
Seek formal training.
Always disconnect
air from the stapler when servicing
or installing staples. During
maintenance, a stapler connected
to air may fire accidentally,
causing serious personal injury.
Do not
connect the stapler to compressed
air that exceeds 120 PSI.
Do not use a check
valve or any other fitting that
allows air to remain in the tool.
DO NOT
modify this tool or bypass safety
mechanisms.