Filter
Top Products
-20-
W1808/W1809/W1810 Cyclone Dust Collectors
SET UP
4. Place a large piece of cardboard on the ground to
prevent scrapes from bare concrete for the next
steps.
5. Lay the stand assembly on its side and slide the col-
lector assembly into the stand assembly.
6. Fasten the collector assembly to the stand with (8)
3
/8"-16 x 1" hex bolts, (16)
3
/8" flat washers, and (8)
3
/8"-16 lock nuts, as shown in Figure 16.
7. Model W1808–W1809: Slide the lower legs onto the
upper stand assembly, and fit the lower braces into
the leg notches. Fasten the upper and lower legs
and lower braces using (24)
3
/8"-16 x
3
/4" hex bolts,
(16)
3
/8"-16 x 1" hex bolts, (80)
3
/8" flat washers,
and (40)
3
/8"-16 lock nuts. Refer to the W1808 and
W1809 Parts Breakdowns on Pages 48 and 51 for
more detail.
Note: On Model W1810, the lower legs will be
installed in Step 19, on
Page 23.
Note: It will be easier to assemble the lower legs
and braces onto the upper stand assembly if you
keep the fasteners loose.
8. Place the 3 x 6 x 1800mm roll of foam tape on the
intake cylinder, as shown in
Figure 18.
Figure 18. Foam tape adhered to intake
cylinder.
Figure 17. Collector assembly fastened to
the stand, Model W1808-09.
Lower Brace
Lower Leg
Figure 16. Collector assembly fastened to
the stand, Model W1810.