Filter
Top Products
-25-
W1808/W1809/W1810 Cyclone Dust Collectors
SET UP
23. Install the three drum latches, as shown in Figure
32, with (6) 10-24 x
3
/8" Phillips head screws and (6)
10-24 hex nuts.
Model W1809/W1810: Use the remaining (6) 10-24
x
3
/8" Phillips head screws and (6) 10-24 hex nuts to
plug the lower latch mounting holes.
24. Model W1808: Assemble the bag holder, as shown
in Figure 33, using the (16) 10-24 x
3
/8 Phillip head
screws and (16) 10-24 hex nuts.
Model W1809 & W1810: Assemble the bag holder, as
shown in
Figure 33, using the (24) 10-24 x
3
/8 Phillip
head screws and (24) 10-24 hex nuts.
25. Install the rubber handles (Figure 33) on the inside of
the bag holder with the (4)
1
/4"-20 x
5
/8" hex bolts, the
(8)
1
/4" fender washers, and the (4)
1
/4"-20 hex nuts.
26. Insert the bag holder into a plastic dust collection
bag, then insert the bag holder into the collector
drum as shown in
Figure 34.
Figure 32. Installing latches on collector
drum.
Figure 34. Bag holder installed into
collector drum, Model W1809.
Figure 33. Bag holder.
Rubber Handles