Filter
Top Products
-11-
Model W1822 (For Machines Mfg. Since 9/10)
SETUP
17. Remove the T-bolt from the knurled pivot handle
of the crosscut fence and set it aside for use in the
next steps.
18. Slide the miter gauge bar into the sliding table miter
gauge slot, as shown in Figure 13.
19. While holding the crosscut fence in position, rotate
it slightly so that you can insert the T-bolt you
removed from the handle in Step 17 into the fence
slot and into the sliding table miter gauge slot, as
shown in Figure 13.
20. Position the fence along the table, then tighten the
forward miter gauge bar set screw (see Figure 13)
and the miter gauge lock knob (see Figure 14) to
secure the fence in place.
21. Use a square to position the fence exactly 90° to the
saw blade, then thread and tighten the two knurled
pivot handles with a plastic washer onto the fence
bolts, as shown in Figure 14.
Note: The handles have different thread sizes and
each will only fit a specific bolt.
Figure 14. Pivot handles installed.
Point Cap Screws
Pivot
Handles
Lock Knob
Figure 13. Installing the fence T-bolts into
the sliding table miter gauge slots.
Forward
Set Screw
T-Bolt