Filter
Top Products
-14-
Model W1831 (For Machines Mfg. Since 2/12)
SETUP
Place the spindle hex nut, table inserts, sanding drums
and sleeves, and spindle washers in the appropriate sized
accessory slots beneath the table.
Note: A sanding drum does not need to be installed until
after the test run.
Assembly
Figure 7. Table inserts, drums, and sleeves
placed on sander base.
Sanding Drums
and Sleeves
Table Inserts
DO NOT operate this machine without an adequate
dust collection system. This machine creates substan-
tial amounts of wood dust while operating. Failure to
use a dust collection system can result in short and
long-term respiratory illness.
Recommended CFM at Dust Port: ................ 100 CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the
dust port, you must take into account many variables,
including the CFM rating of the dust collector, the length
of hose between the dust collector and the machine, the
amount of branches or Y's, and the amount of other open
lines throughout the system. Explaining this calculation
is beyond the scope of this manual. If you are unsure of
your system, consult an expert or purchase a good dust
collection "how-to" book.
Dust Collection
Figure 8. Dust port location.
1
1
⁄2" Dust Port