Filter
Top Products
-19-
Model W1831 (For Machines Mfg. Since 2/12)
MAINTENANCE
MAINTENANCE
Cleaning
Schedule
MAKE SURE that your machine is
unplugged during all maintenance pro-
cedures! If this warning is ignored, seri-
ous personal injury may occur.
To clean your machine, vacuum excess wood chips and
sawdust, and wipe off any remaining dust with a dry cloth.
Sawdust and other particles can also work their way under
the table insert, so this area also needs to be cleaned.
Sanding sleeves can be cleaned with the PRO-STIK
®
clean-
ers on Page 18.
To clean the table:
1. DISCONNECT SANDER FROM POWER.
2. Remove sanding drum and table insert as described in
the Sanding Drum/Sleeve Installation instructions on
Page 17.
3. Wipe or vacuum out any dust or particles that have
accumulated beneath the table insert on the table
opening, shown in Figure 14.
4. Re-install table insert and sanding drum.
5. To protect the table from rust, coat the table surface
with a quality metal protectant.
Figure 14. Table insert area.
Spindle
Washer
Table Insert
Sanding Drum
and Sleeve
Spindle
Hex Nut
Table Opening
Base Washer
For optimum performance from your machine, follow this
maintenance schedule and refer to any specific instructions
given in this section.
Before Each Use
After Each Use
Monthly Maintenance
• Clean/vacuum dust buildup from inside the sander
body and off of the motor.
• Inspect the sanding drums and sleeves for wear or
damage.
• Check for worn or damaged wires.
• Check for any other unsafe condition that could
hamper operation of this machine or cause potential
injury.
• Turn the sander OFF .
• Clean up any sawdust or particle residue from the
machine.
• Protect table.