Filter
Top Products
For Machines Mfg. Since 8/09 Model SB1023
-33-
MAINTENANCE
Long-term storage
Machine Storage
Machinery can develop serious rust problems and
corrosion damage if it is not properly prepared
for storage. If decommissioning this machine, use
the steps in this section to ensure that it remains
in good condition.
Short-term storage (less than
year)
1. DISCONNECT MACHINE FROM POWER!
2. Thoroughly clean all unpainted, bare
metal surfaces, then coat them with a rust
preventative oil or wax specifically designed
to protect machinery while in storage. DO
NOT USE MOTOR OIL in storage situations
as it does not sufficiently protect against
rust.
3. Lubricate the machine as outlined in the
Lubrication section on Page 30.
4. Cover and place the machine in an area
that is out of direct sunlight and away
from where paints and thinners are stored,
or where gasses are present. Fumes and
sunlight can bleach or discolor paint and
clear plastic guards.
5. Once or twice a month, depending on
humidity, wipe down the machine as
outlined in Step 2.
6. Every two months, move all handwheels so
the headstock and column move at least once
in their full range of motion. This will keep
the bearings, bushings, gears, and shafts
well lubricated and protected from corrosion,
especially during the winter months.
Long-term storage (more than a
year)
1. Empty and flush any cutting fluid pumps,
lines, or tanks.
2. DISCONNECT MACHINE FROM POWER!
3. Thoroughly clean all unpainted, bare metal
surfaces, then coat them with a heavy grease
or rust preventative. Take care to ensure
these surfaces are completely covered but
that the grease or rust preventative is kept
off painted surfaces. Make sure that both
the upper and lower portions of the column
leadscrew are completely coated with white
lithium grease.
4. Remove the table, and then clean and pack
the bearings with white lithium grease.
5. Using mineral spirits, clean and brush the
ways, rack, pinion gear, and the leadscrew
with any quality grease or wax that is
specifically formulated for protecting
machine parts during storage.
6. Open the main electrical box on the machine
and place a few moisture absorbing desiccant
packs at the bottom of the electrical box.
7. Cover and place the machine in an area
that is out of direct sunlight and away
from where paints and thinners are stored,
or where gasses are present. Fumes and
sunlight can bleach or discolor paint and
clear plastic guards.
Note: When the machine is being put back into
service from long-term storage, lubricate
the machine as outlined in the Lubrication
section on Page 30.
Never attempt to move this machine without
first locking the table in place. If the machine
is slightly tilted, the table could uncontrollably
slide and fall off of the machine and cause
machine damage or severe injury.
Service