Filter
Top Products
To disable the taper attachment:
1. DISCONNECT LATHE FROM POWER!
2. Use an 8mm hex wrench, and loosen both
deadman clamp cap screws shown in Figure
26, so the deadman can slide on the way as
the carriage is moved.
Figure 27. Taper angle control knob.
Dovetail
Lock Cap
Screw
Taper Angle Control Knob
3. Using a 6mm hex wrench, loosen both
dovetail lock cap screws (one end shown in
Figure 27).
Figure 26. Deadman clamp location.
Cap Screw
4. Turn the taper angle control knob until you
reach "0" as indicated by the taper scale.
5. Using a 6mm hex wrench, tighten both
dovetail lock cap screws.
For Product Mfg. Since 1/10 Model SB1269
-11-
MAINTENANCE