Filter
Top Products
Inventory
When you are completely satisfied with the
condition of your shipment, you should inventory
the contents.
Inventory (Figure 3) Qty
A. Cap Screws M10-1.5 x 40mm
(Taper Attachment Mounting) ......................4
B. Taper Attachment Assembly .........................1
C. Tapered Pins 8.7 x 7.7 x 47mm .....................2
D. Copper Anti-Score Plug .................................1
E. Deadman Clamp Assembly ........................... 1
F. Deadman Arm and Clevis .............................1
Unpacking
This item was carefully packaged to prevent
damage during transport. If you discover any
damage, please immediately call Customer
Service at (360) 734-1540 for advice. You may
need to file a freight claim, so save the containers
and all packing materials for possible inspection
by the carrier or its agent.
Figure 3. Model SB1269 inventory.
A
B
C
D
E
F
Things You'll Need
This attachment is intended to be a permanent
installation. Installation will take approximately
1.2 hours and require the following items:
For Assembly
• Cotton Rags
• Mineral Spirits
• SafetyGlasses
• Oil Can with any Basic Machine Oil
• Assistant
• Open End Wrench (17mm)
• Hex Wrenches (3, 4, 5, 6, and 8mm)
• Tapered Drill Bit (8mm)
• SafetyGlasses
• Oil Can with Pressure Tip
• Dila Indicator with Magnetic Base
• Phillips Screwdriver, #2
• Hammer
• Drill Bit,
19
⁄64"
• Spiral Pin Reamer, Industrial Size: 6
—Small End Diameter: 0.2773"
—Large End Diameter: 0.3540"
For Product Mfg. Since 1/10 Model SB1269
-3-
PREPARATION