Filter
Top Products
10
OPERATION
NOTE:
The EP30 does not have a power switch.
11. Position the terminal lug of the bonding cable against the
cleaned surface of the rail. Position the gun against the cable
lug so that the brazing pin is at the top edge of the cable lug
hole. See Figure 4 below.
Figure 4. Gun position
IMPORTANT
Make sure the correct ferrule and brazing pin are used.
The pin braze must be made in the top of the hole when
brazing to a vertical surface.
12. Hold the gun rmly with both hands and pull the trigger
once. The electronics will nish the braze automatically.
13. Hold the gun in place for 3-4 seconds after the brazing is
complete to allow for cooling. Then remove the gun straight
backwards without pulling trigger.
14. After the braze has cooled, knock the shank off the braz-
ing pin using a hammer.
15. Use a new ceramic ring for each new pin braze.
NOTE:
A red light indicates low batteries on the unit. Charge
as soon as possible.