Filter
Top Products
6
Tool operators and maintenance personnel must always comply with the safety
precautions given in this manual and on the stickers and tags attached to the
tool and hose.
These safety precautions are given for your safety. Review them carefully before
operating the tool and before performing general maintenance or repairs.
Supervising personnel should develop additional precautions relating to the specic
work area and local safety regulations. If so, place the added precautions in the
space provided on page 5.
The EP30 Electronic Pin Brazing Units will provide safe and dependable
service if operated in accordance with the instructions given in this manual. Read
and understand this manual and any stickers and tags attached to the tool before
operation. Failure to do so could result in personal injury or equipment damage.
• Operator must start in a work area without bystanders. The operator must be familiar with all prohibited work areas
such as excessive slopes, dangerous terrain conditions, and rail trafc.
• Establish a training program for all operators to ensure safe operation.
• Do not operate the tool unless thoroughly trained or under the supervision of an instructor.
• Always wear safety equipment such as goggles, ear, head protection, and safety shoes at all times when operating the
tool.
• Do not inspect or clean the tool while the battery power source is connected. Accidental arcing can cause serious
injury.
• Do not load brazing pins or ceramic rings while the battery power source is connected. Accidental arcing can cause
serious injury.
• Do not use the tool while it is connected to a battery charger.
• Ensure battery charging is only done in a dry environment. Charging batteries in the rain or near standing water
resents an electrocution hazard. Read the safety and operation instructions provided with the battery charger before
using the battery charger.
• Do not operate a damaged, improperly adjusted, or incompletely assembled tools.
• To avoid personal injury or equipment damage, all tool repair, maintenance and service must only be performed by
authorized and properly trained personnel.
• Do not exceed the rated limits of the tool or use the tool for applications beyond its design capacity.
• Always keep critical tool markings, such as labels and warning stickers legible.
• Always replace parts with replacement parts recommended by Stanley Hydraulic Tools.
SAFETY PRECAUTIONS