Filter
Top Products
14 ► FG10/PG05 Service Manual
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Grinder does not run Hydraulic power source not
functioning.
Check power source for proper ow
and pressure (7-10 gpm/ 26-38 lpm
@ 1500-2000 psi/ 105-140 bar.
Couplers or hoses blocked. Locate and remove restriction.
Hydraulic motor failure. Inspect and repair.
Hydraulic lines not connected. Connect lines.
Grinder operates too slow. Hydraulic motor speed to slow. Check power unit for proper ow
(7-10 gpm/26-38 lpm).
High back-pressure. Check hydraulic system for
excessive back-pressure (over 250
psi/17 bar).
Couplers or hoses blocked. Locate and remove restriction.
Oil too hot (above 140°F/60°C) or
too cold (below 60°F/16°C).
Check hydraulic power source for
proper oil temperature. Bypass
cooler to warm oil or provide cooler
to maintain proper temperature.
Relief valve set too low. Adjust relief valve to 2100-2250
psi/145-155 bar.
Hydraulic motor worn. Inspect, repair or replace.
Flow control malfunctioning. Have ow control serviced at an
authorized Stanley service center.
Grinder operates too fast. Flow control malfunctioning. Have ow control and valve body
serviced at an authorized Stanley
service center.
If symptoms of poor performance develop, the following chart can be used as a guide to correct the problem.
When diagnosing faults in operation of the grinder, always check that the hydraulic power source is supplying the
correct hydraulic ow and pressure to the grinder as listed in the table. Use a owmeter known to be accurate.
Check the ow with the hydraulic oil temperature at least 80°F/27°C.