Filter
Top Products
RS25 User Manual ◄ 13
DETACHING THE UPPER AND LOWER
LINKS
The upper and lower links of the rail clamp assembly
can be detached from the motor mount (50) by unscrew-
ing the handle (20).
SAW STORAGE
By disengaging the double cam (52), the rail clamp as-
sembly can be rotated so that the entire saw has a atter
prole for storage.
Do not store the saw with the abrasive wheel attached.
CARE OF ABRASIVE CUT-OFF WHEELS
CAUTION
All abrasive cut-off wheels are breakable and,
therefore, care must be exercised during handling
and storage to prevent damage.
Wheels should be laid on a at, rigid, surface away from
excessive heat or moisture. Wheels should not be stored
where they will be exposed to high humidity, water, other
liquids or freezing temperature. If wheels are supplied
with blotters attached, suitable separators should be
used to preserve atness.
COLD WEATHER OPERATION
If the saw is to be used during cold weather, preheat
the hydraulic uid at low engine speed. When using the
normally recommended uids, uid temperature should
be at or above 50 °F/10 °C (400 ssu/82 centistokes) be-
fore use.
INVESTIGATION OF WHEEL
BREAKAGE
If a wheel breaks during use, a careful investigation
should be conducted by to determine the cause of the
breakage. The cause must then be corrected before us-
ing the saw again.
If unable to determine the cause of breakage, the wheel
manufacturer should be consulted.
OPERATION