Filter
Top Products
51
Reference
Persistent system properties
Property name Meaning
spot.hardware.rev
spot.powercontroller.firmware.version
spot.sdk.version
spot.external.0.part.id
spot.external.0.hardware.rev
spot.external.0.firmware.version
spot.external.1.part.id
spot.external.1.hardware.rev
spot.external.1.firmware.version
The first three of these properties define the hardware,
power controller firmware and SDK software versions
installed on the SPOT. The items starting spot.external.0
define the first external board’s part id (what kind of
board it is), hardware and firmware versions. The items
starting spot.external.1 define the same information for
the second external board. The information about external
boards is updated as a SPOT boots, so the information
will not be correct after boards are added/removed and
before the SPOT is rebooted.
spot.remote.print.disabled Inhibit remote echoing of output from a SPOT
communicating with a remote base station. Defaults to
false. See section Ensure that the remote Sun SPOT is
executing the OTA Command Server.
spot.sectors.reserved.for.streaming There are 30 64k sectors of flash memory available for
application data storage in the SPOT. This property
controls the division of these between flash memory
available to stream over (see section Using
IFlashMemoryDevice) and the RMS system (see section
Using the Record Management Store). By default the
property has the value 8, leaving 22 sectors for the RMS
system.
spot.log.connections Log to System.out each time a radiostream or radiogram
connection is made. Defaults to true. See section Radio
properties.
spot.diagnostics If true, SPOT outputs additional information about
various operations: sometimes useful for support
purposes. Defaults to false.
spot.mesh.enable If true, a SPOT that otherwise has no radio connections
still functions as mesh routing router. Defaults to false.
See section Configuring network features.
spot.mesh.route.logging If true, output detailed information about mesh route
discovery. Defaults to false. See section Configuring
network features.
spot.mesh.traceroute.enable If true, participate in traceroute requests. Defaults to false.
See section Configuring network features.
spot.ota.enable If true, the OTACommandServer is run at startup. See
section Ensure that the remote Sun SPOT is executing the
OTA Command Server.