Universal Laser Systems X2-600 Engraver User Manual


 
Installation 2-5
4 INCH DIAMETER
FLEXIBLE RUBBER HOSE
FRONT VIEW
REDUCE TO 4 INCHES WITH
A REDUCING COUPLER
Y-PIPE
FROM EXHAUST BLOWER
SHUT OFF
GATE
SHUT OFF
GATE
Passing Through a Narrow
Doorway
If the doorway is not wide enough to allow to you roll the laser system through it, the system MUST be
detached from the Cart Stand, rotated sideways, passed through the doorway, then re-attached to the
Cart Stand. If your doorway is wide enough, you can skip the following procedure and proceed to
“Leveling the System”.
The Laser System can weight up to 250 lbs. Obtain assistance from as many people
as possible (3 or 4 people). Always use a back-support device. Do not attempt lifting
the machine if you are physically handicapped or are injured in any way. Seek the
advice of a physician if you are unsure.
It would help if you had a PADDED floor dolly to transport the machine through the
doorway. If one is not available, it will need to be carried through the doorway.
1. Open the Rear Cover by pressing down on the
button part of the latches until the latches pop
up.
2. Fold the Rear Cover down to a resting position.