Filter
Top Products
2-6 Installation
3. Locate and disconnect the two white Power Supply
Cable Connectors. Gently push the cables all the
way down into the cavity of the Power Supply
enclosure. Close and latch the Rear Cover by
pushing down on the latch until it clicks.
4. Remove any packing materials or accessories from
inside the Laser System.
5. Using strong shipping tape or rope, tape the front
door closed so that it does not open up when you
tilt it.
6. Remove the eight(8) screws, flat
washers, and lock washers that attach
the Cart Stand to the Laser System from
the bottom.
7. Lift the Laser System straight up, clearing
the Cart Stand and the Power Supply
Cables. Gently tuck the Power Supply
Connectors into their cavity so they do
not interfere with re-assembly.
8. Place the Laser System face down on
the dolly and roll it through the doorway.
If you do not have a dolly, you will need
to carry it through.
9. After you get the Laser System and the
Cart Stand through the door, line
carefully line up the Laser System and
place it back on top of the Cart Stand.
Be careful not to pinch your fingers.
10. Attach your screws, flat washers, and
lock washers. Re-connect the Power
Supply Connectors, close the Rear Cover
and push down on the latches until they
click and lock the cover into place.
11. Locate the laser system to its final resting
position next to the computer and
exhaust system.
Power Supply
Connectors
Strong Tape