Filter
Top Products
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
A. Accessing the Programming Mode
2. Accessing the Programming Mode Remotely
a. Call into the C-1000A from a Touch Tone phone. Note: Call in from another line to avoid C.O. busy signals,etc.
b. Answer the call using the device on the “PHONES” port.
c. From either phone enter
✱ followed by the six digit security code (see Programming section D).
d. A double beep will indicate that you have accessed the programming mode.
e. You can now Touch Tone program the features listed in section B below.
Note: Programming from a cell-phone may not be suitable in areas with weak coverage.
1. Accessing the Programming Mode Locally (Security Code Bypass Mode)
a. Move DIP switch 2 from OFF to ON (see Programming section E).
b. Call into the C-1000A from a Touch Tone phone. Note: Call in from another line to avoid C.O. busy signals, etc.
c. Answer the call using the device on the “PHONES” port.
d. A double beep will indicate that you have accessed the programming mode.
e. You can now Touch Tone program the features listed in section B below.
f. When finished programming, move DIP switch 2 to the OFF position.
Note: Programming from a cell-phone may not be suitable in areas with weak coverage.
(5)
B. Quick Programming Features
Door strike 1 activation time .5 - 10 seconds (see “Note” below) ............................
Door strike 2 activation time .5 - 10 seconds (see “Note” below) ............................
Auxiliary contact activation time .5 - 10 seconds (see “Note” below) ......................
Note: 00 = .5 seconds, 01-10 = 1-10 seconds, factory set to 00 (.5 seconds).
Auxiliary contact latched while either doorbox is activated ......................................
Auxiliary contact activated in custom ring cadence .................................................
Security Code (factory set to 845464) .....................................................................
Disable all special modes listed below (factory default) ..........................................
Doorbell mode ........................................................................................................
Custom ring mode ...................................................................................................
Multiple relay activation mode .................................................................................
Paging mode ...........................................................................................................
Inhibit latching commands mode ............................................................................
To reset to factory settings ......................................................................................
Note: Multiple modes may be selected.
2 digits (00-10)
2 digits (00-10)
2 digits (00-10)
11
12
6 digits (0-9)
✱0
✱1
✱2
✱3
✱4
✱6
###
+
+
+
+
+
+
#01
#02
#03
#03
#03
#47
Memory
Location
Enter Digits
- then -
Enter Digits
Enter
03 #01
11 #03
12 #03
✱2
Programming the C-1000A...
1. ...to set door strike 1 to activate for 3 seconds
2. ...to set the auxiliary contacts to activate a camera while either doorbox is activated
3. ...to set the auxiliary contacts to activate an external ringer or strobe light in a custom ring cadence
while either doorbox is ringing
4. ...to have doorboxes ring phones in a custom ring pattern
C. Programming Examples
D. Security Code
This six digit number can be used to access the programming mode. The security code has been factory set to 845464
(V-I-K-I-N-G). It is recommended that you change the security code to a personal 6 digit number. To change the secu-
rity code, access programming (see Programming section A). Enter six digits 0-9 followed by #47. If you have for-
gotten your security code, follow the steps in Programming section A, 1. Accessing the Programming Mode
Locally. Note: The security code must be six digits in length and can NOT contain a
✱
or #.