Wagner SprayTech 3.23 Paint Sprayer User Manual


  Open as PDF
of 32
 
12 ProSpray 3.23
GB
Cleaningtheunit(shuttingdown)
8.2 Suction lter
i
A clean suction lter always guarantees
maximum feed quantity, constant spraying
pressure and problem-free functioning of the
unit.
1. Screwoffthelter(Fig.7)fromsuctionpipe.
2. Cleanorreplacethelter.
Carry out cleaning with a hard brush and an appropriate cleaning
agent.
8.3 Cleaning the high-pressure lter
Cleantheltercartridgeregularly.
Asoiledorcloggedhigh-pressureltercancauseapoorspray
pattern or a clogged tip.
1. Turn the pressure control knob counterclockwise to
minimum pressure.
2. Open the relief valve, valve position PRIME
(kcirculation).
3. Switch the unit OFF.
Unplug the power plug from the outlet.
4. Unscrewthelterhousing(Fig.8,Item1).withastrap
wrench.
5. Pulltheltercartridge(2)fromthebearingspring(3).
6. Clean all the parts with the corresponding cleaning agent.
Ifnecessary,replacetheltercartridge.
7. ChecktheO-ring(4),replaceitifnecessary.
8. Placethebearingring(5)againstthebearingspring(3).
Slidetheltercartridge(2)overthebearingspring.
9. Screwinlterhousing(1)andtightenitasfaraspossible
with the strap wrench.
1
4
3
2
5
8.4 Cleaning Airless spray gun
1. Rinse Airless spray gun with an appropriate cleaning
agent.
2. Clean tip thoroughly with appropriate cleaning agent so
that no coating material residue remains.
3. Thoroughly clean the outside of the Airless spray gun.
Intake lter in Airless spray gun
Disassembly (Fig. 9)
1. Pullprotectiveguard(1)forwardvigorously.
2. Screwgrip(2)outofthegunhousing.Removeintakelter
(3).
3. Intakeltercongestedordefective–replace.
Assembly
1. Placeintakelter(3)withthelongconeintothegun
housing.
2. Screwingrip(2)intothegunhousingandtighten.
3. Slotinprotectiveguard(1).
W
arning:
keep clear
of tip
250 bar
m
ax.3600 psi
3
2
1
Uncontrolled Copy
 previous next