Wagner SprayTech 524009 Paint Sprayer User Manual


  Open as PDF
of 24
 
Finish 230 AC Compact 11
GB
Spraying Spraying Technique
5.3 Pressure Relief Procedure
Be sure to follow the pressure relief procedure when
shutting the unit down for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for
cleanup.
1. Turn the pressure control knob counterclockwise to its lowest
setting.
2. TurnthePRIME/SPRAYvalvetothePRIMEposition.
3. Trigger the gun to remove any pressure that still may be in the
hose.
4. Lockthegunbyturningthegunlocknutclockwise(when
lookingfromthebackofthegun)untilitstops.Thisclosesthe
material valve in the gun.
Injection hazard. Do not spray without the tip guard
in place. NEVER trigger the gun unless the tip is
completely turned to either the spray or the unclog
position. ALWAYS engage the gun trigger lock
before removing, replacing or cleaning tip.
6. Spraying Technique
The key to a good paint job is an even coating over the entire surface.
Keepyourarmmovingataconstantspeedandkeepthespraygunat
a constant distance from the surface. The best spraying distance is 25
to 30 cm between the spray tip and the surface.
25 - 30 cm
Keepthespraygunatrightanglestothesurface.Thismeansmoving
yourentirearmbackandforthratherthanjustexingyourwrist.
Keepthespraygunperpendiculartothesurface,otherwiseoneend
of the pattern will be thicker than the other.
Trigger gun after starting the stroke. Release the trigger before
ending the stroke. The spray gun should be moving when the trigger
is pulled and released. Overlap each stroke by about 30%. This will
ensure an even coating.
25 - 30 cm25 - 30 cm
i
When nished spraying, perform Pressure Relief
Procedure.
If you expect to be away from your spray project
for more than 1 hour, follow the Overnight Storage
procedure described in the Cleanup section of this
manual.
 previous next