Filter
Top Products
6
Finish 370 / 250
GB
SAFETY REGULATIONS
1.20 SETUP ON AN UNEVEN SURFACE
The front end must always point downwards in order to avoid
sliding away.
2 GENERAL VIEW OF APPLICATION
2.1 APPLICATION
Finish 370 / 250 is an electric driven unit for the airless atomi-
zation of di erent painting materials. Also it is able to feed the
internal feeded paint roller, which is available as accessory.
Finish 370 /250 is made for jobs in the workshop and on the
building site
The unit performance is conceived so that its use is possible
on building sites for small- to middle-area dispersion work.
Finish 250 is designed for varnishing jobs. Small jobs with dis-
persion work are possible.
2.2 COATING MATERIAL
Diluting lacquers and paints or those containing solvents, two-
component coating materials, dispersion and latex paints.
No other materials should be used for spraying without
WAGNER‘s approval.
Pay attention to the Airless quality of the coa-
ting materials to be processed.
The unit is able to process coating materials with up to
15,000 mPas. If highly viscous coating materials cannot be ta-
ken in or the performance of the unit is to low, the paint must
be diluted in accordance with the manufacturer‘s instruc-
tions.
Attention: Make sure, when stirring up with
motor-driven agitators that no air bubbles
are stirred in. Air bubbles disturb when spra-
ying and can, in fact, lead to interruption of
operation.
2.2.2 FILTERING
Su cient ltering is required for fault-free operation. To this
purpose the unit is equipped with a suction lter (Item 1) and
an insertion lter in the spray gun (Item 2). Regular inspection
of these lters for damage or soiling is urgently recommen-
ded.
A high-pressure lter (Item 3) -available as accessory- is rising
up the ltering surface and will make the work more comfor-
table.
2.2.1 COATING MATERIALS WITH SHARPEDGED
ADDITIONAL MATERIALS
These particles have a strong wear and tear e ect on valves
and tips, but also on the heating hose and spray gun. This im-
pairs the durability of these wearing parts considerably.
If possible do not use the unit on an inclined surface since the
unit tends to wander through the resulting vibrations.
Both units are able for all common varnishing jobs like
doors, door frames, balustrades, furniture, woodencladding,
fences, radiators (heating) and steel parts.