Filter
Top Products
pg. 4 of 10 AM16905-001 Rev. A
QL Series
Printer
INTRODUCTION
NOTE: Zebra Technologies Corporation is not liable for personal injury or
damage to any equipment caused by the improper installation of this
equipment to any power source.
The Zebra RCLI-AC Charger system is designed to allow Zebra Technology QL or RW se-
ries Mobile Printers to run off an A.C. power source. It does this by providing intelligent
charging capabilities for the printer’s battery allowing it to run for prolonged periods of time
off A.C. power .
Follow these installation instructions closely to ensure safe, reliable performance of your QL
series printer.
The printer is powered with its own battery which is charged by the RCLI-AC Series
Charger System which in turn runs off your facility’s A.C. power Your facility’s A.C. power
delivery system must be properly installed and maintained to minimize power spikes and
electrical “noise” .
Faulty electrical components within your facility’s A.C. wiring system can create electrical
noise severe enough to defeat the electrical filtering that is built into the printer. When this
happens, printers and any
data device communicat-
ing to them can behave
unpredictably.
The RCLI-AC Charger is
supplied with an output
cable with a special plug
for the printer’s charging
port, and an input power
module which plugs into
an A.C. power source.
Refer to the installation
section of this manual for
more information.
NOTE: Failure to
install this equipment
per these instructions
will void the warranty.
Figure 1
RCLI-AC Charging System
A.C. Power module
Charger
Module