108 CHAPTER 8: CONFIGURING THE DUAL 56K LAN MODEM FOR DIAL-IN SUPPORT
Figure 64 Dial-In Wizard Internet Service Provider Window
8 Select an Internet Service Provider for this dial-in user to use when accessing the
Internet from the remote location.
9 Click Finish.
This completes the server-side portion of the configuration for LAN Modem
Site-to-Site Dial-in. To allow for Site-to-Site configuration, you must also do the
following:
■ Configure this LAN Modem as a client-side device. Refer to “Part II.
Configuring a Client Device for Dial-out Access,” page 109, for instructions.
■ Configure the second site LAN Modem as both a server-side LAN Modem and a
client-side device, following the same procedure that you used to configure
this LAN Modem.
If you wish to use the LAN Modem’s Callback feature, you must configure
Callback parameters for this LAN Modem from the Dial-in User Parameters page.
Refer to “Configuring Dial-in User Parameters,” page 114, for instructions.
Dial-in Wizard for Advanced
Dial-in
To create a Dial-in User Profile for Advanced Dial-in, follow these steps:
1 From the LAN Modem Main Configuration Page, click the Dial-In button.
2 Click the Dial-in Wizard button.
