1-2 CHAPTER 1: INTRODUCTION
■ Automatic EISA configuration without jumpers
■ Three status LEDs
■ Single shielded RJ-45 connector for use at either speed
(Category 3, 4, or 5 UTP cabling for 10BASE-T Ethernet networks,
and Category 5 UTP for 100BASE-TX Fast Ethernet networks)
■ Diagnostic software and drivers on the 3C59X EtherDisk
â
diskette
The Fast EtherLink EISA adapter can be managed remotely
with Transcend
â
PC Link SmartAgent
â
network management
software. Driver agents for this adapter are provided on the
3C59X EtherDisk diskette.
The procedures described in this guide are shown in
Figure 1-1.
Figure 1-1 Procedure Overview
1
Install the adapter in an EISA slot.
2
Use the EISA configuration utility
to configure the adapter.
3
Install network drivers.
(NetWare or other)
4
Troubleshoot the adapter.
(optional)
